OPERATION
The built-in control panel features four operating buttons and a display which shows all operation statuses of the
machine. The control panel allows the user to customize the DMX starting address and output height and switch
on/off the automatic stop of spark output in case of the device tipping over. The machine can be operated with the
wireless or cable remote control. Alternatively, it can be controlled with a DMX controller. DMX control will take
priority over the manual operation.
Operating buttons
Button Function
MENU Selecting menu items
ENTER Activating spark output manually in “Manual Test” mode
UP / DOWN Setting values
Status indicators
Display Function
Heat The device is warming up
Ready The device is ready for spark output
Wait Awaiting next action / spark output disabled via DMX
Clean Cleaning function via DMX active
Menu items
Display Function
Addr DMX512 0-512 Adjusting the starting address
Volume Out 1-100% Adjusting the fountain height
Tip Over ON/OFF
Activating or deactivating automatic stop of spark output in
case of the device tipping over by more than 45°
Note: The tipping sensor is a very important protection
mechanism. It should always be activated.
Manual Test
Manual activation of spark output for test purposes with
ENTER button
To Next Page
Loading...
Need help?
General
