EasyManuals Logo

EUROM Safe-T-Convect User Manual

EUROM Safe-T-Convect
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
Mounting on pedestals
1. Lay the device down on a steady soft surface
(Figure 8, pos. 4).
2. Place the pedestals (Figure 8, pos. 3) on both
sides of the main body (Figure 8, pos. 5).
3. Screw and tighten the pedestals with the
small screws (Figure 8, pos. 1) using a Phillips
screwdriver (Figure 8, pos. 2).
Figure 8
4. Place the device on a horizontal, solid and
non-flammable surface.
5. Place the device with a minimum clearance
distance (Figure 9) of:
100 cm on the top side;
50 cm on the sides;
30 cm on the back side;
50 cm on the front side.
6. Do not place the device immediately below a
socket outlet.
Figure 9
Installation
WARNING
Do not put the power plug into the wall socket before the device is correctly
mounted or stands in the right place.
Do not use an extension cable; this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 2400 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EUROM Safe-T-Convect and is the answer not in the manual?

EUROM Safe-T-Convect Specifications

General IconGeneral
BrandEUROM
ModelSafe-T-Convect
CategoryHeater
LanguageEnglish

Related product manuals