mode is different than heating capacity in normal mode. Both heating capacities need to be
set separately.
Frost mode
The remote control has a Frost button for a frost protection mode; the device maintains the
room temperature between 5°C and 8°C.
1. Press the Frost button to activate.
2. Press the Frost button to deactivate.
With the Max button on the remote control the capacity at which the Frost mode will work
can be chosen: low, medium or high capacity. Please note that the heating capacity in Frost
mode is different than heating capacity in normal mode. Both heating capacities need to be
set separately.
Remote control slot
1. The remote control (Figure 13, pos. 2) can be
placed in the remote control slot (Figure 13,
pos. 1) on the side of the device.
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
1. Make sure the ON/OFF switch is in the OFF position (Figure 10, pos. 1).
2. Disconnect the power plug from the power outlet (Figure 10).
3. Let the device cool down before touching it.
4. Wind the power cable.
5. Remove the batteries from the remote control (Figure 11).
Maintenance
Do not perform any repairs or modifications to this device.
To Next Page
Loading...
Need help?
General