9
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
• Press the MODE button, repeatedly, to select the desired heating function
in the following sequence: Low ( ) heat output --> High heat output
and fan --> Frost protection mode --> Low ( ) heat output and fan -->
Low heat output, etc.
Temperature Selection
The appliance can be set to heat the room to a certain temperature within the
5°C–38°C range.
• Press the UP [ + ] or DOWN [ - ] buttons to set the desired temperature in
one degree steps. The temperature on the display will go to the maximum
temperature that can be set (38°C), then use the DOWN [ - ] button to set
the desired temperature.
NOTE: For the appliance to heat, the set temperature must be set higher
than the indicated equipment temperature.
• When the room temperature rises to more than 2°C above the set
temperature, the heater will switch off. It will come on again when the
temperature has dropped.
• In Frost protection mode the temperature is set to a default setting of 7°C
and cannot be adjusted.
Timer Setting
The heater is equipped with a 24-hour timer which you can set to switch the
heater on or off at a set time. The time that can be set ranges from 1 min. to
23h 59min. You should set the timer after you have set the desired heating
mode and temperature. It is also possible to set both the switch-on and
switch-off time.
• Press the TIMER button and select the timer function in the following
sequence: Switch-on time hour --> Switch-on time minute --> Switch-off
time hour --> Switch-off time minute --> Continuous operation
• While the Switch-On / Switch-Off time is flashing on the display, set the
hours / minutes by pressing the UP / DOWN [ + / - ] buttons.
• When the Switch-Off time has elapsed, END is shown on the display and
the heater switches off.
Turning Off
• Press the POWER button to turn off the heater.
• Press the ON/OFF [ I / O ] button to disconnect it from the power supply.
• When the heater is not going to be used for a while, unplug it from the mains.
Operating Instructions (Cont.)
To Next Page
Loading...
