19
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
Auto mode
• Once the auto mode operation has been selected, the indoor sensor
operates automatically, and will choose between the cooling [ ] and
fan [ ] mode.
– When the room temperature is greater than or equal to 24°C, the unit will
automatically enter cooling mode.
– When the room temperature is less than 24°C, the unit will automatically
enter fan mode.
Cooling mode
In cooling mode, the flexible air exhaust hose MUST be installed.
• Press the MODE button until the cooling mode indicator illuminates.
To set a temperature and fan speed:
– Press the DOWN or UP button repeatedly to set the desired room
temperature within the 15°C to 31°C range.
– Press the SPEED button to select the fan speed: low, medium or high.
When the room temperature is higher than the set temperature, the
compressor will run. When the room temperature is lower than the set
temperature, the compressor will stop.
NOTE: For best cooling efficiency, make sure that:
* Curtains/blinds are closed if your room is directly exposed to the sun.
* The air conditioner is located away from any heat source.
Fan mode
In fan mode, there is no requirement to use the exhaust hose. However, if you
want to remove stale or smoky air from the room, please install the exhaust
hose as described in the “Installation” section.
• Press MODE button to select fan mode; the fan mode indicator will turn on.
• Press the SPEED button to select low, medium or high fan speed.
NOTE: In fan mode, you cannot activate the sleep function or adjust the
temperature.
Instructions (Cont.)
To Next Page
Loading...
