Installation page2
3) Plug the iDRIVE into the top of the pedal assembly.
4) Plug the fly-by-wire plug into the back of the iDRIVE.
5) Locate a suitable place for the control unit to be fitted, please take
into account the impact of LED display on the driver's vision during
night time driving. The Control unit is affixed to the dash using pre-fitted
double sided tape. Surfaces treated with silicon based products will not
allow for a secure fitment. Secure the iDRIVE cable out of the way of
any moving parts and ensure it will not inhibit the driver's operation of
the vehicle's pedal assemblies.
PLEASE NOTE: If after correct fitment your vehicle has limited or no
acceleration and / or dash warning lights become illuminated. Please
remove the iDRIVE, putting the vehicle back to standard and contact
iDRIVE Australia.
To Next Page
Loading...
Need help?
General