Installation page 1
Thank you for ordering your iDRIVE Throttle Controller, this user guide
will take you through everything you need to know to install and make
the most out of your iDRIVE. Installation is straight forward, but please
follow directions carefully. The pins in the factory accelerator plug can
easily be bent which can cause the vehicle to go into limp mode.
Please install as follows:
1) Locate factory fly by wire plug, normally located on top of the
accelerator plug assembly. Although in most cases it is possible to
fit your iDRIVE without removing the accelerator pedal assembly,
this may be required for easier fitment. Incorrect alignment of the
plug could result in the vehicle going into limp mode and the pedal
assembly requiring repair so if you are in doubt, remove the pedal
assembly.
2) Unplug the factory fly-by-wire plug
To Next Page
Loading...