Need help?Do you have a question about the Evco EVBOX1 EVB1204 and is the answer not in the manual?
General| Brand | Evco |
|---|---|
| Model | EVBOX1 EVB1204 |
| Category | Control Unit |
| Language | English |
EVBOX1 is a line of front mounted electrical boards for the management of cold rooms with single-phase compressor.
The drawing shows the outward appearance of the devices and lists their parts.
Details the internal components and how to access them for maintenance or installation.
Presents the physical measurements of the device in millimeters and inches.
Step-by-step guide for mounting the unit, including drilling and fastening procedures.
Important precautions regarding environmental conditions and safe installation practices.
Details configurable inputs, digital outputs, and RS-485 MODBUS port functions.
Diagram showing electrical connections for specific EVBOX1 models.
Instructions for inserting the termination resistor to reduce signal reflections on RS-485 networks.
Essential safety and procedural guidelines for making electrical connections.
Procedure for initial setup, including installation, connection, and basic configuration.
Overview of operating states and basic interface concepts.
Instructions for manually turning the device on and off using the front panel.
Guide on how to view measurements detected by analogue inputs on the display.
Steps to lock and unlock the device's front panel keypad to prevent unintended changes.
Describes fan operation based on humidity levels and compressor status.
How to manually switch between low and high humidity operational modes.
Details on how the energy saving mode is activated and its effects on set points and fan operation.
Information on the types of HACCP alarms the device can store and their associated data.
Procedure for viewing stored HACCP alarms, including critical values and timestamps.
Instructions on how to clear the stored HACCP alarm data from the device.
Overview of data logging capabilities for EN 12830 compliance, file generation, and SD card usage.
Describes the information recorded in CSV files under the HACCP writing mode.
Details the information logged in CSV files when the service writing mode is active.
Information on how the device tracks compressor operating hours for maintenance signaling.
Guide on how to view the total operating hours for the compressor.
Procedure for configuring the device's internal clock and calendar settings.
Instructions for adjusting the primary temperature set point for the system.
Guide on how to access and modify various operational parameters of the device.
Steps to reset the device to its original factory default configuration.
Comprehensive table detailing all configurable parameters, their ranges, and default values.
Explanation of the meaning of the various LED indicators on the device.
Provides meanings for specific codes displayed on the device screen.
Details various alarm codes, their causes, solutions, and main consequences.
Lists error codes, their meanings, and the impact on device operation.
Interface for connecting the device to PC software for configuration and monitoring.
Device for recording operational data to a CSV file format via USB.
Specifications covering device purpose, construction, dimensions, mounting, and protection.
Specifies the allowed ambient operating temperature range for the device.
Details the voltage, frequency, and power consumption requirements for the device.
Details the types, configurations, and specifications of the device's analogue inputs.
Description of the device's digital outputs, including relay types and configurations.
Details the communication port type and protocol used by the device.
To Next Page
