—
20—
-EVE Power CO,LTD Confidential Proprietary-
4.2.4 Other Discharging Modes
Table 12 Continuous discharge rate (unit:P-Rate)
4.3 Safety Limits
4.3.1 Application Conditions
Customer shall ensure strict compliance with the following cell application conditions:
a)Customer shall configure a battery management and monitoring system to strictly
monitor,manage and protect each cell.And a battery management archive shall be established to
keep all monitoring data of the cells,so as to be a reference for problems tracing and product
quality responsibility division. EVE is not responsible for product
quality assurance if no complete monitoring data of the battery system during its service life
is provided.
b)The waterproof and dust proof problems of the cell shall be fully considered in the design of the
pack,and the
pack must meet the waterproof and dust proof grade stipulated by relevant national
standards.EVE is not
responsible for the damage(such as corrosion,rust,etc.)of the cell caused by waterproof and
dust proof problems,
c)It is forbidden to mix different types of cells in the same battery system(or vehicle),other
wise,EVE will not be responsible for the quality assurance.