—
27—
-EVE Power CO,LTD Confidential Proprietary-
● While handling, lift trucks or special tools shall be used to load and unload
products; Handel with care, Do not throw or squeeze,which may cause cell damage or
personal injury.It is strictly prohibited to put cells together with corrosive substances such as
acid and alkali.
5.4 Operation Precautions
● It is strictly forbidden to immerse the cell in water. When it is not in use, i t should be placed in
a cool and dry environment.
● Do not over-charge the cell. Otherwise, cell overheating and fire may occur. During cell
installation and use, hardware and software must be protected against multiple over-charge failures. See
4.3 of this specification for the minimum requirements of protection.
● It's necessary to set a reasonable charging time limit, otherwise, the cell may overheat, resulting in
thermal runaway or fire.BMS management failure of this kind shall be considered during module design.
● If improper charge termination occurs, the root reasons shall be found and resolved before reuse to
avoid negative effects on electrical and safety performances.
● It is forbidden to over-discharge. During the normal use of the cell, charge the cell regularly to
keep the voltage above 2.8 V so as to avoid over-discharge.
● It is forbidden to use or place the cell at a high temperature environment. Otherwise,cell overheat,if
unction failure or life shorten may occur.
● The temperature of the cell shall not exceed 65°C in any normal use,otherwise the BMS must shut
down the cell and stop cell operation.
● Please use a special charger for lithium-ion batteries when charging.
To Next Page
Loading...