Next, slightly loosen the bolts on either side. 2.
Once you have loosened all three bolts, 3.
move the stem to the desired height.
Re-tighten the two side bolts rst, ensuring 4.
they are tightened very well.
Finish by re-tightening the rst bolt located 5.
under the handlebars (the one indicated by
the arrow in Fig. 12).
Depending on how much you moved the stem, you may want to rotate the 6.
handlebars themselves, especially if you need to correct the angle of the brake levers.
Just loosen the two bolts that clamp the handlebar, rotate it to the desired position,
and re-tighten the bolts. (This is described in the section, “Attach Handlebars” on
Page 20.)
Double-check all bolts to make sure they are tight.7.
Front Shock
Please consult the manual provided by the manufacturer.
Tire Inflation
The tires have a range of recommended ination of 40-65 psi. This range is also indicated
on the sidewall of the tire. Lower pressure will give a softer ride. A higher pressure will
provide a rmer ride, but will give the best range per charge.
FIG 13. TWO OPPOSING BOLTS
luna
MODel
To Next Page
Loading...
