21
1. Power On/Off
Press and hold Power button for 1 second to turn on/off the display. The
Displayautomatically turns off when idle for an extended period.
(Default value is 5 minutes.)
2. Pedal Assist Level
Short press "+ / -" button to change the assist level. Top assist level is 5. Level 0
has no motorized assistance.
3. Speed & Mileage mode switch
Short press MODE button to change the speed and mileage mode, as follows:
TRIP-> ODO-> MAX SPEED -> AVG SPEED -> RANGE -> CALORIES->TIME
4. Headlight/backlight On/Off
Press and hold the HEADLIGHT button for 1 second to turn on/off the headlight
and screen backlight.
5. Walking mode (3mph)
Press and hold "-" button for 2 seconds to activate walking mode. Release the
button to stop. While Walking Mode is active, the bike will propel itself forward at
about 3 MPH. Do be careful not to activate Walking Mode while indoors or in any
area where you don’t want the bike to move forward. The purpose of this is so you
can walk alongside your bike when you choose not to ride it. The assist level
displayed will change from a number to a bicyclist icon.
6. Data Reset
Double Press the MODE button quickly to reset temporary data, including AVG
Speed / MAX Speed / Trip / Time.
* These temporary data are not erased by power off.
7. USB PORT -- There is a USB port located on the front edge of the display for
charging cell phones etc. When using this port, make sure that the charge cord for
you accessory in no way will interfere with the operation of the bicycle.
QUICK-START GUIDE TO OPERATING THE DISPLAY PANEL
quest_manual_final_single.indd 20 09/06/2017 19:55
EVELO.COM
To Next Page
Loading...
