3
ASSEMBLING YOUR STROLLER
1
Turn the stroller upside down, as shown, so the rear of the
stroller is facing upwards.
To attach rear wheels, push wheel onto rear leg tube until it clicks
into place. Repeat on other side.
Pull on wheels to make sure both of them are securely attached.
WARNING
To protect flooring, place a protective covering (cardboard,
towel, small rug or blanket) beneath the stroller during
assembly.
Unlatch side frame lock
A
, and lift up on the parent’s handle
B
.
To lock the stroller in the open position, palms must be put under the
parent’s handle to give an upward force away from your body. Pull upward
until the stroller opens fully with an audible click.
Make sure the stroller locks in the open position by pushing down on the
parent’s handle.
Care must be taken when folding or unfolding stroller to
prevent finger injury to you or your child in hinge areas.
A
2
CLICK!
C
To remove, push metal button
C
and pull wheel o stroller.
CLICK!
B
B
DO NOT inflate tires above the maximum recommended
inflation pressure listed on the side of the tire. Over inflation
may cause wheel and/or tire to blowout and could result in
serious injury. Use manual bicycle pump to inflate tires.
To Next Page
Loading...
Need help?
General
