Evenflo PIVOT - Using Your Stroller - Harness

16
Note: Verify the stroller is locked in the open position by lifting up the
rear of the stroller using the parent’s handle.
Lock the rear brakes and remove the bumper bar (page 8).
5-point Harness:
The harness shoulder straps
G
must be at shoulder height or lower,
closest to the baby’s shoulders
H
.
Place the baby in the seat and bring the crotch panel
I
up between
the child’s legs. Fasten each buckle
J
. For a snug, comfortable fit,
pull the shoulder straps
G
to tighten the shoulder restraint and pull
the waist restraint straps
K
to tighten the waist restraint.
Note:
To loosen the waist straps
K
, push in the release button
L
on the buckle
and pull.
To loosen shoulder straps push up on the retainer
M
while pulling down
on the shoulder strap.
Once the child is properly restrained, re-attach the bumper bar.
Make sure the bumper bar locks into position with audible clicks.
Pull on the bumper bar to make sure it is locked into place.
3-point Harness:
To avoid serious injury from falling or sliding out, ALWAYS use
waist restraint.
5-pt Harness
WARNING
I
H
K
G
H
K
G
To change from 5-point to 3-point harness:
Unlock the Harness: Depress button
N
as shown.
Remove harness shoulder strap
G
from each
buckle
J
, as shown.
Store shoulder harness straps for future use.
3-pt Harness
J
G
K
K
I
J
J
G
M
USING YOUR STROLLER - HARNESS
12
L
N