Evenflo REVOLVE360 User Manual

70
Lap Belt Only (Rear-Facing and Forward-Facing)
Installing Lap Belt
10. Grab Base near belt path as shown
and pull side to side and front to back
to make sure Base is installed tightly.
Base should not move more than 2.5
cm (1 in) side to side or front to back at
the Belt Path on the Car Seat.
If Base moves more than 2.5 cm
(1 in), open LockStrong, tension
vehicle belt a little more, and try again.
If Base still moves too much, you may
need to try a different vehicle seat
location, installation method, or both.

Evenflo REVOLVE360 Specifications

General

Type	Convertible Car Seat
Rotation	360-degree rotation
Rear-Facing Weight Capacity	4-40 lbs
Forward-Facing Weight Capacity	22-65 lbs
Harness	5-point harness
Headrest Positions	10
Safety Standards	FMVSS 213
Side Impact Protection	Yes
Machine Washable Cover	Yes
Installation	LATCH or seat belt