EasyManuals Logo

Evenflo SimplyGo User Manual

Evenflo SimplyGo
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
To Sanitize Parts on the Stove:
Place disassembled pump parts (except pump unit, AC adapter, tubing,
tubing adapter, and diaphragm cap) in a pan of boiling water for 5 minutes.
Stir frequently. DO NOT allow parts to rest on bottom of pan as they may
melt or become damaged.
To Sanitize Parts in the Microwave:
This pump may be used with a microwave sanitation device (except pump
unit, AC adapter, tubing, tubing adapter, and diaphragm cap). Please follow
device manufacturer’s instructions.
6
7
Assembling the Flange
D
E
Attach the membrane A to the valve B.
Note: Make sure the membrane is attached
and is lying flat against the valve, or the
pump will lose suction and will not work
properly. Also, make sure the membrane is
not torn, as this too will cause decreased
suction and the pump not to work properly.
2
1
B
A
Push valve assembly C onto the bottom
of the flange D. Rotate bottle E into
bottom of flange.
C
3
Install diaphragm F and diaphragm cap G
to flange assembly H.
Note: Diaphragm cap can can be turned to
orient tubing as desired.
4
Attach tubing I to diaphragm cap G.
Note: If you intend to pump from both
breasts at the same time, repeat steps 1
through 4 for the second flange.
I
G
Before Using Your Breast Pump
F
G
H
After Every Use
Wipe the pump unit with a clean, damp cloth.
Rinse the flange assembly (all parts EXCEPT the pump unit, tubing,
tubing adapter, diaphragm cap, and AC adapter) in cool water to remove
milk residue.
Hand wash with warm, soapy water.
Rinse thoroughly and air dry before assembly. You may also wash your
flange assembly (after rinsing) on the top rack of your dishwasher.
Use care when handling the valve/membrane assembly during cleaning to
avoid damage. Before each use, visually inspect the individual components
for cracks, chips, tears, discoloration or deterioration. In the event that
damage to the device is observed, please discontinue use until the parts
have been replaced.
Inspect the tubing for condensation or milk after each use. If condensation
is observed in the tubing, contact Evenflo for replacement parts.
NEVER immerse pump unit or
AC adapter in water or attempt
to sanitize in a microwave oven.
Damage to parts and oven may
occur. Do not boil or wash tubing
or tubing adapter.
WARNING
Pump unit
AC adapter
Tubing
Tubing
Adapter
Diaphragm
Cap
DO NOT BOIL OR WASH

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Evenflo SimplyGo and is the answer not in the manual?

Evenflo SimplyGo Specifications

General IconGeneral
BrandEvenflo
ModelSimplyGo
CategoryBreast Pump
LanguageEnglish

Related product manuals