Evenflo VICTORY - Stroller Assembly; Product Identification and Parts; Unfolding and Initial Setup; Front Wheel Assembly

3
2
IMPORTANT INFORMATION
IDENTIFICATION OF PARTS
ASSEMBLING YOUR STROLLER
1
2
A
For future reference, record the Model Number and Date of Manufacture below. You can find this
information on one of the rear stroller legs.
Model Number: Date of Manufacture:
Registration Information
Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your personal
information. To register your product, please complete and mail the card that came with it or visit our online registration at
www.evenflo.com/registerproduct.
Front Wheel Assembly
Child’s Tray
(2) Rear Wheel
Wrench for Front Wheel
B
C
E
D
B
A
Child Requirements
Maximum weight: 50 lbs (22.6 kg)
Maximum height: 38 inches (96 cm)
Stroller is for use with children who can sit up unassisted, and is NOT recommended for newborns.
IMPORTANT: Read instructions carefully before use. Save these instructions for future reference. It is very important to assemble
the stroller according to these instructions. DO NOT USE YOUR STROLLER UNTIL YOU HAVE READ AND UNDERSTOOD
THESE INSTRUCTIONS.
If you are missing parts, do not use stroller and call Evenflo ParentLink at 1-800-233-5921 (U.S.A.), 1-937-773-3971
(Canada), or 01-800-706-12-00 (Mexico) to order replacement parts.
Grab the parents handle
B
near the top of the canopy and
pull upward until the stroller opens fully with an audible
click. Make sure the stroller locks in the open position by
pushing down on the parent’s handle.
Unlatch side frame lock
A
.
Continue holding the lock open
while unfolding the stroller.
WARNING
Care must be taken when folding or unfolding
stroller to prevent finger injury in hinge areas.
NOTE: Hardware for front wheel assembly is located
on wheel.
Turn the stroller upside down so the front of the
stroller is facing upwards, as shown.
Loosen the nut on each side so that the forks
C
will fit under the silver tabs
D
. Slide the front wheel
onto the forks. Ensure the silver tabs fit into the
openings on the forks as shown. Use the wrench
tool
E
to tighten both nuts.
DO NOT inflate tires above the maximum
recommended inflation pressure listed on the side
of the tire. Over inflation may cause wheel and/or
tire to blowout and could result in serious injury.
Use manual bicycle pump to inflate tires.
WARNING FALL HAZARD
Wheel can detach and cause tip over. Pull on the
wheel to assure it is securely attached. Periodically
check wheel to assure it is securely attached.
To protect flooring, place a protective covering
(cardboard, towel, small rug or blanket) beneath
the stroller during assembly.