H9 User Guide System Mode
38
To Select the Control Source
Turn the Knob to select the Control Source. The choices are:
[PDL] Expression Pedal
[KB0]…[KB9] - Parameter Control Knobs
[TIP] Aux Switch Tip
[RNG] Aux Switch Ring
[T+R] Aux Switch Tip+Ring
Note: Assigning parameter knobs (KB0-KB9) allow you send MIDI messages ‘through’ the H9
when using H9 Control.
To Assign the Control Source to a Destination
Press the Right Footswitch to select the MIDI Continuous Control that will be assigned to the
H9 Control Source. The choices are:
[OFF] – Control Source unassigned
[C0] – [C99] - MIDI Continuous Controller from 0 to 99
Press the Left and Right Footswitches to toggle between Source and Destination to make as
many assignments as you wish. The default patch is as follows: [PDL.C15] and [KB0.C22]
through [KB9.C31]
Press the PRESETS button once to back-up one level to MIDI menu.
Press the PRESETS button twice to go to top level System menu.
To Next Page
Loading...
