Eventide H9 - [CTL.XMT] - MIDI Continuous Controller Transmit Enable (ON, OFF); [PGM.XMT] - MIDI Program Change Transmit Enable (ON, OFF); [SYS ID] - MIDI Sysex ID (ID 1-ID 16)

H9 User Guide System Mode
40
Press the Right Footswitch to select Prg No. field (indicated by the flashing Right Footswitch
LED), turn the Encoder to select the corresponding number.
Note: MIDI Program Change Transmit must be enabled in order for the H9 to transmit
Program Change messages. MIDI Program Change Transmit is turned ON or OFF in the MIDI
menu. Default is OFF.
Note: When an H9 Preset is recalled with a MIDI program change message, MIDI Program
Change messages are not generated.
Press the PRESETS button once to back-up one level to MIDI menu.
Press the PRESETS button twice to go to top level System menu.
[CTL.XMT] – MIDI Continuous Controller Transmit Enable (ON, OFF)
Press the HOTKNOB button to select. Turn the Knob to set MIDI Continuous Controller
transmit ON or OFF. This setting determines if Parameter transmit MIDI control messages are
enabled.
Press the PRESETS button once to back-up one level to MIDI menu.
Press the PRESETS button twice to go to top level System menu.
[PGM.XMT] – MIDI Program Change Transmit Enable (ON, OFF)
Press the HOTKNOB button to select. Turn the Knob to set MIDI Program Change transmit ON
or OFF. If ON, a MIDI Program change message is transmitted whenever a Footswitch is
pressed for Preset load.
Press the PRESETS button once to back-up one level to MIDI menu.
Press the PRESETS button twice to go to top level System menu.
[SYS ID] – MIDI SysEx ID (ID 1-ID 16)
Press the HOTKNOB button to select. Turn the Knob to choose the MIDI SysEx ID for Backup
and Restore of Presets and System settings.
Press the PRESETS button once to back-up one level to MIDI menu.
Press the PRESETS button twice to go to top level System menu.