6
THE SETTING OF THE REFRIGERATING ROOM
THE SETTING OF ON/OFF
Press and hold ON/OFF key for 3s in power-on state to enter power-off
state, all loads are turned off, the display panel shows "--" in the refrigeration
and freezing temperature display area, and the power is displayed normally;
in power-off state, press the ON/OFF key for 3s to enter power-on state, and
refrigerator is operating normally.
POWER INDICATOR
The power indicator is displayed on the display panel. When the input voltage is
greater than 12.5V, the Full icon light is on. When the input voltage is less than
12.5V and greater than 11.5V, the Mid icon light is on.
THE SETTING OF THE FREEZING ROOM
The LED display turns bright when the door is open. Push the 'freezer' button.
The buzzer rings. Then the freezing room turns into the setting condition. The
temperature turns flash and the temperature of the freezing room increases 1.
It will recycle from “-15” — “-19”.
Warning: The temperature will be set successfully and the flash will disappear if
stop setting over 5 seconds.
The LED display turns bright when the door is open. Push the “Fridge” button.
The buzzer rings. Then the refrigerating room turns into the setting condition.
The temperature pattern turns flash and the temperature of the refrigerating
room increases 1. The temperature will recycle as “01”—“02” —“03”—“04”—
“05”—“06”—“07”— “——”—“01”. When the temperature turns “07”, push the
“Fridge” button , then the refrigerator turns into the condition of pre-closing the
refrigerating room and the LED display turns “——” with flashing light.
To Next Page
Loading...
Need help?
General
