7
LIGHTING AND ITS REPLACEMENT
When the door of refrigerating room opens, the LED light turns on.
When the lighting is damaged, please remove the lampshade first and then
replace the LED lighting.
The specific operations are shown in the following diagram:
1. Please move the lampshade and the thermostat out 3-5mm in the
direction of the arrow.
2. Take out the lamp shade and thermostat downwards.the arrow.
3. Pull the connection terminal, use the screwdriver to remove the
LED light board and replace it.
Note: If the LED lamp is abnormal, it should be replaced by
professionals. Do not take dismantling and replace it privately in
order to avoid damage.
To Next Page
Loading...
Need help?
General
