INSTALLATION REQUIREMENTS
LOCATION REQUIREMENTS
To ensure the beverage cooler operates at optimum you should install it
in a location where there is proper air circulation and electrical connections.
•
This appliance is designed for indoor use only and should not be used outdoors.
Do not install your beverage cooler in any location that is not properly insulated
or heated e.g. garage etc. Your beverage cooler was not designed to operate in
temperature settings below 55°F (13°C) or above 90°F (32°C).
NOTE: When the room temperature is colder than the control set
temperature, the beverage cooler cooling will not operate until the room
temperature becomes warmer than the set temperature.
•
Select a suitable location for the beverage cooler on a hard even surface away
from direct sunlight or heat source e.g. radiators, baseboard heaters, cooking
appliances etc. Any unevenness should be corrected with the leveling legs
located on the front and rear corners of the beverage cooler.
RECOMMENDED CLEARANCES
6
ENGLISH
To Next Page