Evercraft 776-3758 - Continued Safety and Product Details; Lead Exposure Warning; Spray Gun Description; HVLP Model Features

776-3758 3 Rev. 07/21/14
WARNING
FAILURE TO OBSERVE THESE WARNINGS COULD RE SULT IN IN JU RY.
 3.Extremeorawkwardfinger,wrist,orarmpositions.
 4.Excessivedurationoftheactivity.
 5.Vibration.
 6.Repeatedpressureonabodypart.
 7.Workingincoldtemperatures.
 CTD'scanalsobecausedbysportsactivities.Pain,tingling,
 ornumbnessintheshoulder,forearm,wrist,hands,orfingers,
 especiallyduringthenight,maybeearlysymptomsofaCTD.
 Donotignorethem.Shouldyouexperienceanysuchsymptoms,
 seeaphysicianimmediately.Otherearlysymptomsmayinclude
 vaguediscomfortinthehand,lossofmanualdexterity,and
 nonspecificpaininthearm.Ignoringearlysymptomsand
 continuedrepetitiveuseofthearm,wrist,andhandcanlead
 toaseriousdisability.
WARNING: Handlingthebrasspartsofthisproductwillexposeyou
tolead,achemicalknowntotheStateofCaliforniatocausebirth
defectsandotherreproductiveharm.Wash hands after handling.
IMPORTANT PRECAUTION INFORMATION - READ BEFORE
USING THIS SPRAY GUN:
SPRAY GUN DESCRIPTION
The776-3758isalightweight,anodizedaluminum,general
purposegravityfeedspraygundesignedforuseinvarioustypes
ofsprayingapplications.The776-3758canhandlewaterbased
andsolventbasedsprayingapplications.
IMPORTANT:Thisspraygunmaybeusedwithmostcommon
coatingandfinishingmaterials.Itisdesignedforusewithmildly
corrosiveandnon-abrasivematerials.Ifusedwithotherhigh
corrosiveorabrasivematerials,itmustbeexpectedthatfrequent
andthoroughcleaningwillberequiredandthenecessityfor
replacementofpartswillbeincreased.
HVLPMODEL776-3758
ThisHVLPspraygunwasmanufacturedtoprovidemaximum
transferefficiencybylimitingaircappressureto10psig(complies
withrulesissuedbySCAQMDandotherEPAairqualityauthorities).
ThisHVLPspraygunwillproduceapproximately10psigcap
pressureat36-43psigguninletpressure,asmeasuredatthegun
inlet.Anaircaptestkitshouldbeusedtoinsure10psigcap
pressureisnotexceeded.OrdertestkitpartnumberRSTK58.
Formaximumtransferefficiency,donotusemorepressurethan
isnecessarytoatomizethematerialbeingapplied.
Connecttheguntoaclean,moistureandoilfreeairsupplyusing
ahosesizeofatleast5/16"I.D.hose.Donotuse1/4"I.D.hose.
(25'x1/4"hoseat18cfmhasapressurelossof25psig.25'x
5/16"hoseat18cfmhasapressurelossof8psig.)