EVERCROSS A1 - Page 14

12
H1 Motor high temperature 1. Stop riding or riding scooter at low speed, avoiding
climbing.
2. Check whether the motor wire is damaged, and
whether the temperature signal wire of the motor wire
is short-circuited to the ground.
3. Replace the motor.
BP Over voltage, emergency 1. Check whether scooter has been fully charged, riding
the scooter at low speed, avoiding braking suddenly
when scooter is fully charged.
2. Restart. Check if firmware has been wrongly upgraded.
3. Replace the control board.
BH High voltage alarm 1. Check whether scooter has been fully charged, riding
the scooter at low speed, avoiding braking suddenly
when scooter is fully charged.
2. Restart.
3. Check if firmware has been wrongly upgraded.
4. Replace the control board.
BL
Low voltage alarm 1. Stop riding and get scooter charged.
2. Restart.
3. Check if firmware has been wrongly upgraded.
4. Replace the control board.