DO NOT USE NON-EVERCROSS PRODUCTS WITH
YOUR EV12M ELECTRIC SCOOTER.
The EV12M has been built to certain EVERCROSS
design specifications. The original equipment supplied at
the time of sale was selected on the basis of its compati-
bility with the frame, fork and all other parts. Certain
aftermarket products may or may not be compatible.
① Aligne hole of the rear shock absorber and
hole of the rear fork.
② Put on M8*40mm cylindrical head screws with
socket head L cap, then covered with M8 nylon
lock nut at the other end.
③ Tighten the screws and nuts by a 6mm Allen
key and 13mm open-end wrench.
07
ASSEMBLY AND SET-UP
Rear shock absorber
Rear fork mount
*
To Next Page
Loading...