What to do if the lights and motor don't work on my Everdure Ventilation Hood?
If the lights and motor aren't working, check your house fuses and reset or replace them if they've blown. Also, ensure the power cord is properly fitted into the outlet and the outlet is switched on.
How to fix insufficient suction on my Everdure RBES63 Ventilation Hood?
If your Everdure Ventilation Hood isn't providing enough suction, it might be too far from the gas top. Try refitting the range hood to the correct distance.
How to fix oil leakage from my Everdure RBES63?
If you're experiencing oil leakage, it could be due to a loose one-way valve or U-shaped section. Try taking down the one way valve and sealing it with sealant. Alternatively, if the leakage is from the connection of U-shaped section and cover, take the U-shaped section down and seal it.
Why is the light on but the motor isn't working on my Everdure RBES63?
If the light is on but the motor isn't working, first, make sure the fan switch is in the correct position. If the issue persists, it could be due to a failed fan switch or motor, and you should contact Everdure Service.
How to fix lights not working on Everdure RBES63 Ventilation Hood?
If the lights on your Everdure Ventilation Hood aren't working, the most likely cause is broken or faulty globes. Replace the globes as per the instructions.
What to do if my Everdure RBES63 inclines?
If your range hood is inclining, the fixing screw might not be tight enough. Tighten the hanging screw to make it horizontal.
What to do if the Everdure Ventilation Hood light is on, but the motor doesn't work?
If the light is on but the motor isn't working on your Everdure Ventilation Hood, there are several potential causes. First, the impeller leaf might be blocked; if so, get rid of the blockage. Alternatively, the capacitor could be damaged, requiring replacement by an authorized person. It's also possible that the motor bearing is damaged or jammed, or that there's a bad smell coming from the motor, both of which necessitate motor replacement by an authorized technician.
Why is my Everdure RBES63 Ventilation Hood leaking oil?
Oil leakage from your Everdure Ventilation Hood can occur if the one-way valve and air ventilation entrance aren't tightly sealed; in this case, take down the one way valve and seal with sealant. Another cause could be leakage from the connection of the U-shaped section and cover, which requires taking the U-shaped section down and applying sealant.
Technical specifications including voltage, frequency, lamp type, and power rating for the range hood models.
Lists all components and accessories provided with the range hood for installation and use.
Lists the tools recommended or necessary for the proper installation of the appliance.
Details the steps for wall mounting the RBES63, RBES65, RBES91, and RBES96 range hood models.
Details the steps for wall mounting the RBES64 and RBES92 range hood models.
Explains how to operate the RBES92 model using electronic controls and fan speed selection.
Details operating the RBES63, RBES64, RBES65, RBES91, RBES96 models via push buttons for fan and light.
Steps for replacing light bulbs in RBES63 and RBES91 models, including bulb type and removal.
Steps for replacing light bulbs in RBES64 and RBES92 models, including bulb type and removal.
Instructions for replacing light bulbs in RBES65 and RBES96 models, specifying bulb type.
General| Width | 60 cm |
|---|---|
| Speeds | 3 |
| Number of Motors | 1 |
| Number of Speed Settings | 3 |
| Lighting | LED |
| Material | Stainless Steel |
| Filter Type | Aluminum |
To Next Page
