After spraying, rinse all surfaces and vegetation.
1. Using fresh water from a garden hose, rinse any vegetation that may
have come into contact with soft wash mix.
2. Rinse surfaces from top to bottom. Rinse until there are no visible
suds on the cleaned surface.
To extend the life of the bleach pump system's replaceable pump
cartridge:
1. Fill tank with fresh water.
2. Remove spray nozzle from gun and pump fresh water through the
system, discharging spray onto a hard surface such as a driveway.
3. Do not let the pump/sprayer freeze.
NOTE: The pump cartridge is a wear item and will fail in time. There are two
failure modes: 1.) Decreased performance or 2.) An internal leak (red LED
light on motor illuminates). See instructions in the Maintenance section for
replacing the pump cartridge.
If the pump must be left unattended at any time:
a) Disconnect power to the pump.
b) Relieve system pressure.
If the pump becomes clogged or inoperative during use, discontinue use
immediately.
- DO NOT attempt to service while chemicals are in the pump and power is
connected.
- Return to service area to review instructions for troubleshooting before
attempting to service.
To Next Page
Loading...
