Everlast PD1 - Personal Information Setup

SETTING YOUR PEDOMETER
ENGLISH l 7
-Press Mode key to go into pedometer mode
-Press and hold the ADJ/EL key for 2 seconds to set
the info in the following order: Age/Measurement
Unit/Weight/Walking Stride/Running Stride/Target
Step
-Press ST/STP key to increase the seng value, while
press RESET key to decrease; Pressing and holding
the buon will change the value rapidly.
-When the value is correct, press MODE to move to
next. Connue to press MODE and change values as
required unl the pedometer returns to the age
item. Press ADJ/EL key to confirm the seng and go
back to pedometer mode.
-There are 10 icons which show the progress of your
step to the target steps at the top of LCD screen.
Note: The pedometer will automacally go back to
the me mode if there is no input for 20 seconds in
the SETUP mode.