To Next Page
K
Kayla MorrisSep 16, 2025
What to do if my Everlast Cutter power input circuit breaker trips repeatedly?
- JjnewmanSep 16, 2025
The circuit may be improperly sized.
What to do if my Everlast Cutter power input circuit breaker trips repeatedly?
The circuit may be improperly sized.
Why does the arc sputter on my Everlast Welding System?
If your Everlast Welding System's arc sputters, it could be due to inadequate airflow or air pressure, or an improperly sized nozzle. Try decreasing the nozzle size as amps are lowered and increase the air pressure to 73 psi while air is flowing through the torch. Also, check the tightness of the consumables.
Why does the arc blow out when ready to cut with my Everlast Welding System?
If the arc “Blows Out” when ready to cut with your Everlast Welding System, it's likely due to air pressure that is too high. Reduce the pressure to 72 psi.
How to troubleshoot a Everlast Welding System that won't turn on?
If the Everlast Welding System machine will not turn on, and there is no fan or display, check the cords and wiring in the receptacle, the circuit breaker, and the plug condition.
What to do if the 'OK to cut' light is not on and the Everlast Cutter will not start arc?
Increase the air pressure and make sure air is connected.
Why won't the pilot arc transfer and amps read approximately 25-27 amps while switch is held on my Everlast Cutter?
Check the work clamp connection and ensure any rust is removed from the work clamp contact area. A faulty clamp may also be the cause. The arc continuity may not be sensed.
What to do if my Everlast Cutter arc blows out when ready to cut?
If the arc blows out when you're ready to cut, the air pressure might be too high. Try reducing it to 72 psi.
Why is there premature wear on my Everlast Cutter consumables?
Premature or uneven wear on consumables and melting of the cup can be caused by moisture or oil contamination of the consumable. It may also be caused by excessive pilot arc time, improper cutting technique, or incorrect piercing technique.
How to fix unstable arc at lower amps on Everlast Welding System?
If you're experiencing an unstable arc at lower amps with your Everlast Welding System, the consumable orifice size may be too large. Reduce the orifice size.
Why arc does not start when nozzle is rubbed on Everlast Welding System?
If the arc does not start or spark when the nozzle is rubbed on the metal with your Everlast Welding System, it may be due to a blown fuse, an IGBT issue, or a PCB issue.
General
