What to do if my Everlast Cutter won't turn on?
If your Everlast Cutter isn't turning on, begin by inspecting the cords and wiring for any visible damage or loose connections. Next, check the circuit breaker to ensure it hasn't tripped. If you've checked these items and the machine still fails to power on, contact Everlast Support for assistance.
Why my Everlast Power runs but won't cut?
If your Everlast Cutter runs but doesn't cut, ensure you have a solid ground connection. Verify that the ground cable and Plasma Torch are securely attached to the lug and receptacle. Then, confirm that the Auto/Standard switch is in the correct position for your intended use, referring to the Auto/Standard operation section for guidance.
How to improve cut quality on Everlast Power?
To improve the cut quality on your Everlast Cutter, start by checking and adjusting your machine settings. Experiment with increasing or decreasing the air pressure. Also, inspect your consumables for any signs of wear and replace them if necessary.
Why are electrodes and tips rapidly consumed on Everlast Power?
Rapid consumption of electrodes and tips in your Everlast Cutter may be due to inadequate airflow, water contamination in the air supply, or poor cutting technique. Return to stand-off cutting of no more than 1/8 inch.
What to do if there is heavy slag on the underside of the cut with complete cut through when using Everlast Power?
If you're experiencing heavy slag on the underside of the cut with complete cut through while using your Everlast Cutter, it's likely that your travel speed is too slow or your standoff is too much (more than 1/8 inch). Try increasing your cutting speed or reducing the cutting amperage to better suit the metal thickness.
Why does the Over current LED illuminate on my Everlast Power?
The Over current LED on your Everlast Cutter illuminates because the duty cycle has been exceeded. To resolve this, allow the machine to cool down. Also, make sure that the fan is not blocked, ensuring proper ventilation.
How to fix a beveled cut on one side with Everlast Cutter?
To correct a beveled cut on one side while using your Everlast Cutter, decreasing the standoff and increasing the air pressure can help reduce or eliminate the problem. Always orient the bevel toward the parent piece so that the part remains true.
Why is the air pressure warning light on my Everlast Power Cutter illuminated when the pressure gauge shows adequate pressure?
If the air pressure warning light is on while the pressure gauge displays adequate pressure on your Everlast Cutter, it indicates an internal leakage around the air fittings. Consult with Everlast Support for instructions, if needed.
What to do if the Pilot Arc will not energize on Everlast Power?
If the Pilot Arc on your Everlast Cutter will not energize, check the machine fuse. If the fuse is intact, contact Everlast Support for further assistance.
Why is the arc unstable on my Everlast Cutter?
An unstable arc on your Everlast Cutter may be caused by a poorly grounded unit or a worn electrode.
General| Input Frequency | 50/60 Hz |
|---|---|
| Air Flow Rate | 4.5 CFM |
| Duty Cycle | 60% |
| Cooling Method | Air-cooled |
| Input Phase | Single Phase |
To Next Page