To Next PageTo Next PageWhat to do if my Everlast POWERPRO 256SI Welding System won't turn on?
If your Everlast Welding System isn't turning on and the power indicator light is off, begin by inspecting the power cords and wiring at the plug. Also, check the circuit breaker to ensure it hasn't tripped.
General| Input Voltage | 240V |
|---|---|
| Input Phase | Single Phase |
| Input Frequency | 50/60 Hz |
| Output Current Range | 10-250A |
| Output Range (TIG) | 10-250A |
| Processes | MIG, TIG, Stick |
| Rated Output (MIG) | 250A |
| Rated Output (TIG) | 250A |
| Output Range (MIG) | 250A |
| Duty Cycle | 60% |
General safety guidelines and precautions regarding high frequency electromagnetic interference.
Details on protective gear, radiation hazards, and personal safety measures during welding.
Step-by-step instructions for connecting the TIG torch, foot pedal, and gas supply.
Instructions for connecting the plasma torch, air supply, and work clamp for plasma cutting.
Guidance on setting up for stick welding, including polarity and cable connections.
Details on rear panel connections for gas, power, and optional accessories like water coolers.
Techniques for performing plasma cuts, including edge and piercing start methods.
Common issues and solutions for the TIG welding process and the main unit's operation.
Common problems encountered during plasma cutting and their respective solutions.
