Everlast POWERTIG 185 DV

Need help?

Do you have a question about the Everlast POWERTIG 185 DV and is the answer not in the manual?

Summary

Section 1 Introduction and Specifications

PowerTIG 185 DV Overview and Specifications

Overview of the PowerTIG 185 DV welder, its accessories, and detailed technical specifications.

Welding Operation Guides

Guides for polarity, amperage, and tungsten selection for TIG and Stick welding operations.

Key Welder Features Explained

Detailed explanations of the welder's core features, controls, and operational modes.

Quick Setup and Configuration

Instructions for initial setup, including TIG torch connection and stick electrode holder configuration.

Section 2 Know Your Machine

Front Panel Layout and Controls

Identification and explanation of all controls, indicators, and connectors on the welder's front panel.

Rear Panel Layout and Connections

Identification and explanation of rear panel connections, power switch, gas fitting, and adapter.

Point Gap Adjustment Procedure

Step-by-step guide for adjusting the point gap on the HF board for optimal arc starting.

Section 3 Getting Started

Tungsten Preparation for Welding

Proper techniques for grinding and preparing tungsten electrodes for TIG welding.

TIG Welding Arc Starting Methods

Methods for initiating a TIG arc, including lift start and high frequency start procedures.

Stick Welding Arc Starting Methods

Techniques for striking an arc using the tapping or scratch/match method for stick welding.

Torch and Pedal Connections

Detailed view of TIG torch components and the wiring diagram for the 22K Ohm foot pedal connector.

Section 4 Trouble Shooting

Common Welding Issues and Solutions

Troubleshooting common problems like no power, no weld, unstable arc, and poor weld quality.

Understanding Error Codes

Explanation of error codes displayed by the welder and their potential causes.