Everpower Electronics EP12M248 - Temperature & Safety Protection; Recommended Settings

3
http://www.oceanpowercharger.com

Temperature sensor
Temperature & Safety Protection:
INTERNAL OVERHEAT PROTECTION: The charger is equipped
with built-in overheat and overload electronic circuit protection
 TIMER PROTECTION: Charger provides the maximum charging
time for each charging stage. In the event it is wired to recharge a
larger than recommended battery, charger will stop charging after
maximum stage recommended time and the RED LED will be FLASH
slowly. At this point, Battery must be disconnected.
REVERSE POLARITY: Charger has reverse battery protection. (Red
LED ON, while output leads are connected backwards), Disconnect
and correct connection to battery.
SHORT CIRCUIT PROTECTION: Charger will turn off upon
detecting a short circuit (Red LED ON.
RECOMMENDED SETTINGS:
Charge Rate:
Charge Current
1A
2A
4A
8A
Battery Capacity:
Charging (AH)
4--20
6--40
10--80
40--160
Battery Capacity:
Maintaining (AH)
4--30
6--60
10--100
40--200
Battery type:
Battery type
(Voltage value at 25℃ )
Absorption
Voltage
Float
Voltage
MAX