6
http://www.oceanpowercharger.com
Check electrolyte levels if possible.
(As they may need topping up with distilled water after charging)
THE CHARGING PROCESS:
The charging stages and performance are as follows:
Battery initial condition check
After all connections are made, the charger will automatically diagnose
battery condition.
If battery voltage is above 9V, charger will go into soft start stage.
Otherwise, charger will go into desulphation mode. If the battery voltage
does not exceed 9V after 6 hours of rejuvenation, you will need to
disconnect the battery and check its condition, voltage rating or if it is
connected to a load while charging.
Smart Charging Stages
Desulphation:
20% charging LED: ON.
Engage high peak pulse for deep-discharge or sulphated battery
dissolve the lead sulphated crystal bring the electrolyte fluid to
well-distributed state
The battery voltage will increase slowly.
Soft start:
20% charging LED: ON.
The battery voltage will increase slowly.
Bulk :
80% charging LED: ON.
The battery can be charged about 80%.
The charger delivers an almost constant current 2000mA until the
battery voltage reaches the set value.
Absorption :
80% charging LED: ON.
The battery can charge up to almost 95%.
The charging current tapers and the charging voltage are kept
constant at the set value.
Test Mode
The charging is interrupted for a short period while battery voltage
is measured.
If the battery voltage falls too quickly, the battery could be faulty.
FULL LED: Flashing.
Recondition charging
Charger will go into this stage if battery fails Test Mode due to its
condition, age or being under charged.
This stage can recover batteries from deeply discharged state
increasing performance and battery life.
FULL LED: Flashing.
Float mode
To Next Page
Loading...
