Everpower Electronics EP12M248 - LED Status Indication Table

7
http://www.oceanpowercharger.com
Full LED: ON.
The float mode allows the charger to effectively be left connected
to your batteries; it works at a safe level and ready for use.
 Maintenance mode
Full LED: ON.
The program engages a special charging waveform and
monitors the battery voltage variety, if the battery voltage sinks, the
special pulses will keep the battery in optimal state, if the battery
voltage drops even lower, the battery charger will switch into bulk
charging . The maintenance mode allows the charger to be
connected to the battery over the course of a season; If possible,
check the electrolyte liquid level in the battery.
LED status indication table:
LED
Status
Description
GEL
Green
GEL Battery Charging
WET
Green
Flooded, WET battery Charging
AGM
Green
Sealed, AGM, VRLA & Calcium Battery
Charging.
20%
Green
20% capacity charging.
80%
Green
80% capacity charging.
100%
Flash
Test Mode or recondition charging.
100%
ON
Fully charged, maintaining the battery.
Fault
ON
Output short –circuit or reverse polarity.
Fault
Flash
Battery is Defective or capacity is too large
100%
ON
2 LEDs are lighting together. Battery is over voltage.
Fault
Flash