EVERSPRING SE203 - Operation; Troubleshooting; Maintenance

Operation
1. Alarm Activation:
When an alarm is activated, the siren will activate its siren and strobe light for
3 minutes (default setting), the icon will show as below.
2. Tamper Protection:
The siren is protected by a tamper switch which is compressed against the
mounting surface when mounted. Whenever the siren is removed from
mounted location, or its cover opened, the tamper switch will be activated and
the siren will send a tamper open signal to remind the user of the condition..
Maintenance
1. When the battery becomes low, the siren will report back to the controller and
LED will flash 20 times. ( The siren will not emit beep-beep sound only LED flashes
20 times when disarm mode.)
2. Once mains power loss, the siren will report to the controller and shift to backup
batteries.
Software reporting commands
Auto report
When battery is inserted, it will report to controller after 2
minutes. It will report tamper/battery/siren and DC adaptor
condition every hour.
Status change
Tamper switch is release: It will report to controller and will
activate alarm sound.
Temperature report
It will report to controller every half of hour.
Power Supply
report
When first power on, it will report power source to controller
after 2 minutes. And then it will report every hour.
Troubleshooting
The troubleshooting table lists some possible causes and solutions. Please contact
your original retailer or nearest service center if the below solutions cannot solve
your problem.
Symptom
Possible Cause
Recommendation
LED on siren not
illuminating
Improper battery
connection or reverse
polarity
Check if 4 batteries are
inserted properly.
Siren is out of order
Do not attempt to open
the casing as it will
invalidate the warranty.
Send it for repair.
LED on siren operating,
but cannot learn the ID
code or take control of
siren
Failure learning the ID
code under Siren
controlled system
According to the
operating instruction,
resume learning the ID
code process.
Ensure it is set at siren
controlled
system
Radio channel
interference
Wait for a moment to start
operating
The siren doesn’t
respond to alerts and
system changes.
The binding process has
failed
Please follow the
instructions about pairing
to controller.
The siren cannot
communicate with the
controller.
Place the siren closer to
the controller.