Fault Code Fault Description Fault Processing
Computer shows faul t code“E3”.
Other areas show blank. After 10
seconds, the treadmill will go into
ready mode and can be restarted.
Possible Reasons
：
An overloaded
electrical surge will send the
machine into self preservation
mode. Check that there is no
burning smell coming from the
motor, If yes, please call the service
number located on the front cover of
this manual. Make sure the power
and voltage comply with the
standard,
E4
Incline self-learning
fault
Check that the incline motor wire
andACwireareconnected
correctly; ensure the wire is not
damaged. After this is completed
,pressthebuttononthecontroller
and star t the self lear ning
E6
Explosion-P roof
Pr otection
：
Some
unusual condition of
power or voltage that
cause damage to the
motor drive circuit.
Start and stop fault status. The
computer will buzz 9 times and show
the“E6”codeonthescreen.Gointo
the ready mode and re start the
treadmill. Possible reason: The
power or voltage is not enough or
the controller is faulty. Make sur e
that all of the wires are connected
cor rectly
Prevent Fall Protection:
F olding machine.
E3
Cur rent over load
Pr otection
：
E9
Put he machine flat
To Next Page
Loading...
