Evo REV 600 - Page 11

EVO REV 600 ELLIPTICAL TRAINER
Visit us at: www.evofitness.com
11
ASSEMBLY
STEP 4:
First connect the Wire Harness – Upper (114) to the Wire Harness – Middle (113) and Hand Pulse Sensor Wire – Upper
(116) to the Hand Pulse Sensor Wire – Middle (115) as shown in FIG 6.
Attach the Handrail – Left (7) to the Side Upright – Left (5) and secure using two M8 x 15mm Allen Head Bolts (74).
NOTE:
Make sure all wires are recessed into the Upright, do not trap or pinch any of the wires.
74
7
5
113
114
116
115
FIG.6