EVOCA Kalea Plus - Network; Wi-Fi and Bluetooth Configuration; 3 G Settings and Firewall

01-2018 5035 01 67
NEtwork
Only for Plus models.
The network congurations vary according
to the network and/or the chosen telephone
provider and the network protections adopt-
ed.
wi-fi
Enables and congures the Wi-Fi connec-
tion of the equipment.
Enable the equipment to connect to Wi-Fi.
The equipment supports the main Wi-Fi
encryption systems (cryptography).
“Open” encryption does not guarantee any
type of protection.
By activating the Wi-Fi connection, the
equipment shows which Wi-Fi networks are
available for connection.
Choose the name of the Wi-Fi network
(SSID) to connect to; if the Wi-Fi network is
hidden, it is necessary to know the name
(SSID) and enter it manually.
The network parameters (such as IP ad-
dress, ...) can be:
- assigned automatically (DHCP)
or
- manually.
-
eters, there must be a DHCP server on

The parameters relating to safe-
guards and password for access to the

The MAC address is a unique address
assigned by the manufacturer that identies
the network card of the equipment.
The MAC address cannot be changed.
bluEtootH
Enables and congures the Bluetooth con-
nection and allows data exchange (short
distance) between the equipment and other
devices.
To connect to a Bluetooth device you need
to:
- enter the equipment identifier.
- make the equipment discoverable when
searching for Bluetooth devices.
In detection mode, a wireless signal allows
the device to be detected by other devic-
es.
- enter the authentication code and associ-
ate the Bluetooth device.
When a device can be detected, the pairing
mode is also usually enabled.
All associated devices are shown.
3g sEttiNgs
Enables and congures the 3G connection
parameters.
Enable the 3G connection in order to view
and congure the parameters.
The parameter values (for example, APN
address, access data, ...) vary according
to the chosen telephone service provider:
request them from your service provider.
firEwall
Enables / disables the rewall to protect
incoming connections to the equipment.