EVOCA Kalea Plus - Removing the Product Containers; Container Removal and Handling

01-2018 5035 01 77
moDEls witH a cappucciNo makEr
1
4
2
3
5
Fig. 53
1. Nozzle-moving handle
2. Mixer nozzle (models with a cappuccino maker
only)
3. Instant beverage nozzles
4. Movable nozzle cover
5. Flow divider nozzle
moDEls witHout a cappucciNo makEr
1 3
4
2
Fig. 54
1. Nozzle-moving handle
2. Movable nozzle cover
3. Coffee nozzle
4. Instant beverage nozzles
REMOVING THE PRODUCT
CONTAINERS


absence of the containers to the con-
trol electronics.
If the sensor does not detect the con-
tainers, the grinders are disabled.
To remove the product containers (coee
beans or instant products) simply remove
the handle and then lift the container from
behind.
Always lift the container from behind
so that the grinders are disabled; non-
compliance with this procedure can be
a source of injury to people (accidental

When the handle of the container is pulled,
it closes the shutter and simultaneously
releases a container from the appliance.
When reassembling, reposition the contain-
er and push the handle inside the container.
Make sure that the container is properly
secured to the appliance.
1
2
Fig. 55
1. Handle
2. Magnet