To Next PageTo Next Page
Need help?Do you have a question about the EVOKO NASO and is the answer not in the manual?
General| Mounting | Wall mount |
|---|---|
| Category | Control Systems |
| Manufacturer | Evoko |
| Product Name | Evoko Naso |
| RAM | 2 GB |
| Certifications | CE, FCC |
| Connectivity | Wi-Fi, Ethernet |
| Processor | Quad-core |
| Ports | USB |
Read all safety warnings and instructions carefully to avoid serious injury or equipment damage.
Unmount the back plate and mark the device height from the floor, ensuring clearance from walls/doorframes.
Use a spirit or laser level to mark accurate hole positions on the wall for the mounting bracket.
Decide the direction for cable exit and use cable clips to manage wires.
Mount the back plate, ensuring correct cable exit, and use suitable screws/plugs for the wall type.
Mount the device onto the bracket by snapping it into place and securing with the safety screw.
Ensure mounting screws are flush with the wall mount for a clean and secure installation.
Clean glass with alcohol, ensure dryness, and apply a horizontal tape as a guide for the adhesive foil.
Press the adhesive foil onto the glass with firm force, removing any trapped air bubbles.
Press the bracket into the foil with force for 20 seconds and allow it to bond for 20 minutes.
Route cables through channels, then mount the device onto the bracket by snapping it into place.
Secure the device by screwing mounting screws flush with the wall mount.
For any questions about the product, visit the official product support website.
