4
EN
Standard wall mounting instructions
IMPORTANT!
Read the safety instructions carefully before using the mounting instructions!
1. Unmount the back plate of the device, by carefully turning it counter clock wise. Mark out the height from oor to center of
device approximately 1500 mm / 5 ft. and not closer to a wall or doorframe than 120mm / 4,72”.
2. Use a spirit or laser level to adjust it horizontally and vertically. Use the holes in the back plate to mark out hole positions on
the wall. Make sure that the markings are exactly leveled and drill the holes for the mounting bracket.
3. Decide on the direction you want to exit the cables and use the cable clips to hold the cables in place.
Note! If you plan to route cables into the wall, mark out the middle in the opening in the back plate.
4. Make sure the hole for the cable exit is facing the direction where you route the cables and mount the back plate to the
wall.
Note! Use 2
–
4 screws depending on the structural capacity of the wall. Always drill holes and use suitable plugs for wall types
such as concrete, plaster etc. Choose a screw type that is suitable for the type of plug and wall concerned. Use screws with a
diameter of 4
–
5 mm / gauge # 7 - 10 and minimum length of 35 mm / 1- 3 /8”. If uncertain always contact a specialist or
dealer for assistance with wall mounting.
Note! Do not remove the protective lm on the back of the mounting bracket. The “sticky surface” should only be used for
glass wall mounting.
5. Mount the device on the bracket by tting the talons on the back plate with the holes in the device and gently turn it
clockwise to snap it in place. Secure it with the safety screw.
6. Secure it by screw out the screws to be ush with the wall mount. One on the same side as the cable outlet and the
other on the opposite side.
For the latest instructions go to: www.evoko.se/downloads
To Next Page
Loading...