Evolution DISC CUTTER - Operating Instructions - Usage; Using Dust Extraction; Trigger Switch Operation

13
www.evolutionpowertools.com
EN
USING A DUST EXTRACTION MACHINE
A workshop dust extraction machine can be attached to the
Evolution Disc Cutter.
£ WARNING: Dust can be very dangerous. We strongly
recommend that a suitable dust extraction machine (not
supplied) is used with this machine to keep the workplace as
clean and safe as possible.
The suction hose from the dust extraction machine should be
attached to the dust extraction port of the Disc Cutter.
• Removetherubbercapfromthedustextractionportand
store it safely for future use.
• Pushtheconnectionhosefromthedustextractionmachine
into the dust extraction port of the Disc Cutter. FIG. 4
• Followallinstructionssuppliedwiththedustextraction
machine when using such with this Disc Cutter.
• Ensurethatthehoseandpowercableofanyattacheddust
extraction machine do not pose or cause a trip or any other
form of hazard to the operator.
• Whenthedustextractionmachineisnolongerrequired,
remove it from the Disc Cutter and replace the rubber cap to
the dust extraction port.
THE ON/OFF TRIGGER SWITCH
This machine is equipped with a safety start trigger switch.
To start the tool:
• Pushinthesafetylockbutton(Fig. 5a) on the side of the
handle with your thumb.
• Depressthemaintriggerswitch(Fig. 5b) to start the motor.
£ WARNING: Never start the saw with the cutting edge of the
saw blade in contact with the workpiece surface.
FIG. 4
FIG. 5a & 5b
a b