Evolution DISC CUTTER - Cutting Advice - Preparation; Pre-Cutting Preparation; Wheel Guard Adjustment

14
www.evolutionpowertools.com
PRE-CUTTING ADVICE
• Ensurethatthepowersupplymatchestherequirements
specified on the machines rating plate.
• Ensurethatthemachinestriggerswitchisinthe‘OFF’
position. If the machine is connected to a power source with
the trigger switch in the ‘ON’ position, the machine could
start operating immediately with the possibility of a serious
accident occurring.
• Ifanextensioncableisrequireditmustbeasuitabletype
for use outdoors and so labelled.
• Themanufacturersinstructionsshouldbefollowedwhen
using an extension cable.
• Routeanyextensioncablesothatitdoesnotposeatrip(or
any other) hazard to the operator or any bystanders.
WHEEL GUARD ADJUSTMENT
The Wheel Guard is adjustable and should be positioned to
provide the operator with the best combination of personal
protection and visibility of the cutting area.
£ WARNING: Ensure that the machine is disconnected from
the power supply before adjusting the Wheel Guard.
• LoosentheWheelGuardlockingknobandrotatetheGuard
to the required position. FIG. 6
• SecurelytightentheWheelGuardlockingknobtolockthe
Guard in place.
Note: The tightness of this locking knob and the security of the
Wheel Guard should be checked regularly when operations
commence.
FIG. 6
CUTTING ADVICE