Evolution TWISTER User Manual

12
www.evolutionpowertools.com
GETTING STARTED
ASSEMBLY
The Mixing Paddle
Note: The Evolution Twister is supplied with a two (2) piece
Mixing Paddle.
The two pieces of the Mixing Paddle simply screw together (Fig. 1)
and should be securely tightened using the spanner supplied.
The Mixing Paddle to the Twister Motor Unit
Note: The machines arbor (Fig. 2) projects from the
TwisterMotorUnit,andhastwo(2)atsmachinedonitto
accommodate the supplied spanner.
The internal hole in the arbor contains a Ø14 mm thread. This
internal thread matches the external Ø14 mm thread found on
the Mixing Paddle shaft.
The Mixing Paddle should be screwed into the machines arbor
and securely tightened.
Note: The machines arbor should be held with a spanner to
prevent it from rotating when the Mixing Paddle is attached
to the Twister Motor Unit.
TEMPORY STORAGE
Ensure that when the Twister is placed on a work-surface etc
the Motor Unit is as shown in (Fig. 3) with the power cord
emerging vertically from the handle.
Fig. 1
Fig. 2
Fig. 3

Evolution TWISTER Specifications

General

Brand	Evolution
Model	TWISTER
Category	Mixer
Language	English