5
www.evolutionpowertools.com
EN
(1.6)
Note: The vibration measurement was made
under standard conditions in accordance with:
BS EN 61029-1:2009
The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one
tool with another.
The declared vibration total value may also be
used in a preliminary assessment of exposure.
(1.7)
VIBRATION
WARNING: When using this machine the
operator can be exposed to high levels
of vibration transmitted to the hand and
arm. It is possible that the operator could
develop “Vibration white nger disease”
(Raynaud syndrome). This condition
can reduce the sensitivity of the hand
to temperature as well as producing
general numbness. Prolonged or regular
users of this machine should monitor
the condition of their hands and ngers
closely. If any of the symptoms become
evident, seek immediate medical advice.
• Themeasurementandassessmentof
human exposure to hand-transmitted
vibration in the workplace is given in:
BS EN ISO 5349-1:2001 and
BS EN ISO 5349-2:2002
• Manyfactorscaninuencetheactual
vibration level during operation e.g. the
work surfaces condition and orientation
and the type and condition of the machine
being used. Before each use, such factors
should be assessed, and where possible
appropriate working practices adopted.
Managing these factors can help reduce
the eects of vibration:
Handling
• Handlethemachinewithcare,
allowing the machine to do the work.
• Avoidusingexcessivephysicaleorton
any of the machines controls.
• Consideryoursecurityandstability,and
the orientation of the machine during use.
Work Surface
• Considertheworksurfacematerial;
its condition, density, strength,
rigidity and orientation.
WARNING: The vibration emission during
actual use of the power tool can dier from
the declared total value depending on the
ways in which the tool is used. The need
to identify safety measures and to protect
the operator are based on an estimation
of exposure in the actual conditions of use
(taking account of all parts of the operating
cycle, such as the times the tool is switched
o, when it is running idle, in addition to
trigger time).
(1.8)
LABELS & SYMBOLS
WARNING: Do not operate this machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools
for replacement labels.
Note: All or some of the following symbols
may appear in the manual or on the product.