3.1.4 AirKey padlock
The AirKey padlock is a battery-operated locking component for use in barrier systems,
roller shutters, depots, and archive containers both indoors and outdoors.
Access is via an electronic authorisation check on the underside. A hardened steel shackle is
used for locking. Both unlocking and locking can only take place by manually turning the
electronic knob of the AirKey padlock after a successful authorisation check.
Please check whether the AirKey padlock is suitable for your intended application. The
AirKey padlock is available in different designs and configurations.
The required data sheet as well as the product catalogue is available on our homepage in the
download section: https://www.evva.com/en/downloads/.
The AirKey padlock has an optical and an acoustic signal. The explanation of the various
signals can be found under Locking components signals.
Follow the assembly manual enclosed with the packaging during assembly of the AirKey
padlock.
Assembly tools for the AirKey cylinder, hybrid cylinder, lever cylinder, and padlock
AirKey cylinders, hybrid cylinders, lever cylinders and padlocks are protected against
manipulation with a special mechanism. The electronic thumb turn can be removed with
special tools only. The required assembly tools for assembly, disassembly, and those to
change the batteries are not enclosed with the AirKey cylinder as standard and for this
reason, they must be ordered separately.
The order code can be found in the AirKey product catalogue on our homepage in the
download area https://www.evva.com/en/downloads/.
3.1.5 AirKey wall readers
AirKey wall readers are suitable for indoors and outdoors, surface-mounted, or flush
installation and for areas critical to security.
Please use the dedicated seal enclosed with the product for use outdoors or in areas that are
exposed to water as well as in the event of surface-mounted installation. Observe the
information in the assembly manual.
AirKey wall readers are connected to the AirKey control unit using CAT5 cables (max. 100 m,
loop max. = 2 Ohm) to supply them with power. The AirKey control unit is supplied with
power by the mains adapter and in the event of a power cut it features a data buffer for a
maximum of 72 h, providing the AirKey control unit had previously been in operation for a
minimum of six hours.
To Next Page
Loading...