AirKey system manual version 2.7 |
06/03/2024 | Subject to technical changes and misprints
As a result, the locking component status is adapted within the entire
system. The maintenance task is no longer shown and the correct firmware
version is indicated in the locking component details.
Open the door and secure it against accidentally slamming shut during
firmware updates. Subsequently check the locking component operates as
intended before you once again close the door.
When updating locking component firmware, ensure a stable Internet
connection is available and the data connection does not cut out during the
firmware update. For this purpose, a host of settings are available,
depending on the corresponding smartphone and operating system (e.g.
permit automatic network changes between mobile data networks and Wi-Fi
networks).
EVVA recommends to always keep locking component firmware up to date.
8.5 Updating the Keyring version of media
In the AirKey system, "Keyring" is the name of a software program that manages all AirKey-
relevant data stored on passive access media such as cards, key fobs, combi keys, and
wristbands. If new Keyring versions become available for such media, this information is
shown in the media details of each medium, in the maintenance tasks, on the Home screen
and upon updating locking components.
The medium’s current Keyring version is shown in the locking component
details section.
You can use smartphones or optionally available coding stations to update media’s Keyring.
Activate the special authorisation "maintenance authorisation" on the smartphone to enable
Keyring updates using the smartphone. Proceed as follows to update the Keyring using
smartphones:
> Establishing a connection using NFC (for Android smartphones):
Tap the Connect to component icon .
> Establishing a connection using Bluetooth (for Android smartphones and iPhones):
Select the Encoding media menu item from the AirKey app main menu – refer to
Encoding media.
To Next Page
Loading...