the cylinder‘s memory.
3 Terminate programming mode.
Even after assigning a new programming key, all user keys
previously assigned to this e-primo cylinder retain their
validity.
Resetting to factory settings
You can reset the e-primo cylinder to its factory settings so
that all settings made, like assignments of media, blocking,
ofce and emergency opening functions, are deleted from
the cylinder‘s memory.
1 Loosen (turn clockwise) the inside thumb turn‘s xing
screw with the special ZTOOL1 Allen wrench and pull off
the outside thumb turn.
2 Press the INIT button.
Ü
During the deletion process a sequence of tones will be
emitted and the light ring will illuminate alternately in
red, orange and green.
Ü
A higher pitched tone will be emitted, the light ring will
illuminate orange. The e-primo cylinder‘s memory is now
in its delivered state.
3 Fasten the inside thumb turn by carefully screwing
in (counter-clockwise) its xing screw with the special
ZTOOL1 Allen wrench.
Notice: Please note that any person who has access
to the ZTOOL1 Allen wrench is able to reset the
e-primo cylinder back to its factory settings.
Be aware, after resetting to factory settings, media
must again be assigned to the e-primi cylinder
before you close the door.
Limiting the INIT button‘s function
To avoid misuse, the functionality of the INIT button can
be limited to the owner of the programming key.
l
Hold the programming key for about 5 seconds at the
reader.
Ü
A sequence of ascending tones will be emitted, the light
ring blinks green. The e-primo cylinder can now only be
reset to factory settings if the programming key is being
held at the reader.
You can remove this limitation by holding the program-
ming key at the reader again for 5 seconds.
Notice: Be sure that a delete key has been created
for the programming key. Otherwise, if the pro-
gramming key is lost, the e-primo cylinder must be
returned to EVVA for restoration.
To Next Page
Loading...