EVVO INTENSA 10 - Espresso Coffee Preparation; Steam Milk Foam Function

CAFETERA ESPRESSO EVVO INTENSA 10/10S
21
ENGLISH
with the “ ” mark. (Fig.2)
3. Plugin the power cord, press the “ ” (ON/OFF button), the power indicator is
illuminated. “ ” (making espresso button) indicator is not illuminated. the
machine starts to warm up.
(Make sure that the steam control knob is “OFF”. If it is “ON”, the three indicators will
ash together and appliance will not work.)
4. When the indicator of “making espresso button” is always on, press the making
espresso button to get hot water for washing the coffee mesh or coffee cup.
4. Make espresso coffee
1. While the machine is preheating, the ground coffee powder (the coffee powder
should be no. 1 powder, not too thick or too ne) can be loaded into the “metal mesh”
and then compressed with the tamper; Meanwhile, clean the coffee powder at the
edge of the portalter with a brush or hand (if 1-cup is needed, use 1-cup mesh; if
2-cups are needed, use 2-cup mesh). (Fig.3)
2. Insert the portalter and lock it tightly as lock position , then place the coffee
cup under the portalter
3. When the “ ” (making espresso button) light is illuminated, press the” ”
(making espresso button) and the coffee starts to ow out. At the same time, adjust
the position of the coffee cup to let the coffee liquid ow into the cup along the cup
wall, Press the “ ” (making espresso button) again if you need more coffee.
4. It’s done when the coffee no longer ows out.
5. Steam milk foam function
1. Press “ ” ON/OFF button and then” ” milk frothing button. At this time, the
“ ” milk frothing button indicator starts ashing until the indicator turns on
normally and the preheating is completed.
2. Pour the iced whole milk into the milk pitcher 1/3 of the way, insert the steam nozzle